User's Manual
Watertight Transmitter
Rio Rancho, NM
17
Straight Whip Antennas
This is a full size cutting template used to cut the
length of the whip for a particular frequency. Lay the
uncut antenna on top of this drawing and trim the whip
length to the desired frequency.
After cutting the antenna to the desired length, mark
the antenna by installing a color cap or sleeve to indi-
cate the color listed in the table below.
The supplied caps can be used several different ways:
1) A color cap on the end of the whip
2) A color sleeve next to the connector with a black cap
on the end of the whip (trim the closed end of the
colored cap off with scissors to make a sleeve).
3) A color sleeve and color cap (cut the cap in half with
scissors).
21
22
23
24
25
26
27
28
29
20
19
470
944
Whip Length
Note: Check the scale of your printout - his line should be 6.00 inches long (152.4 mm)
NOTE:
Not all Lectrosonics products are built on all of the blocks covered in
this table.
Factory supplied antennas precut to length include a label with the
frequency range. Label is not supplied with this kit.
470 470.100 - 495.600 Black w/ Label 5.67”
19 486.400 - 511.900 Black w/ Label 5.23”
20 512.000 - 537.500 Black w/ Label 4.98”
21 537.600 - 563.100 Brown w/ Label 4.74”
22 563.200 - 588.700 Red w/ Label 4.48”
23 588.800 - 614.300 Orange w/ Label 4.24”
24 614.400 - 639.900 Yellow w/ Label 4.01”
25 640.000 - 665.500 Green w/ Label 3.81”
26 665.600 - 691.100 Blue w/ Label 3.62”
944 944.100 - 951.900 Black-w/Label 2.62”
BLOCK FREQUENCY CAP/SLEEVE ANTENNA
RANGE COLOR WHIP LENGTH