User's Manual

Venue 2 Wideband Receiver
LECTROSONICS, INC.
20
RX MENU
TOP MENU links back to the Top Menu for
overall system setup.
FREQ ADJUST opens a setup screen to
manually select the frequency of each
receiver module.
NOTE: The setting for 100 or 25 kHz frequency
increments is in the TX Menu under STEP SIZE,
selectable on a per channel basis.
AUDIO LEVEL is used to adjust the output
level of each receiver. The built-in tone
generator is also enabled in this screen.
SMART NR sets the desired noise reduc-
tion mode for each channel: NORMAL,
FULL or OFF.
PHASE sets the polarity (phase) of each
output to the desired value: NORMAL or
INVERTED.
RX LINK (DIVERSITY LINK) selects
adjacent receivers to be paired for Ratio
Diversity operation, or to be operated
individually with Antenna Phase Switching
Diversity.
COMPAT MODE sets the DSP-based
compatibility mode for each channel.
NOTE: If your Lectrosonics Transmitter is
set to Nu Hybrid Compatibility Mode, set
the receiver to Euro Digital Hybrid Wireless
®
(EU
HYBR). Make certain the COMPAT mode is set
to match the mode in the transmitter for optimum
audio quality.
TALKBACK enables the Talkback Mode on
the desired channels and selects the
output channel for the talkback audio.
GROUP TUNING opens setup and editing
screens to select and modify user defined
frequency groups U, V, W and X, or NONE
for each receiver module.
SQUELCH BP bypasses the squelch
(muting) function on a per module basis for
diagnostic purposes.
CAUTION: Reduce the gain or volume
level of the sound system or recorder before
bypassing the squelch. Very loud noise will be
present at the bypassed channel.
MODULE POWER turns the power ON or
OFF on each receiver module. Normally
used to prolong operating time when the
receiver is powered by battery.