User's Manual

Digital Hybrid Wireless

Modular Receiver System

Rio Rancho, NM, USA

Step 5

Align the ﬂats on the BNC connectors with the ﬂats in

the holes in the front panel and secure them with the

lock washers and nuts.

Step 6

Route the coaxial cables underneath the front panel

jack covers, replace the covers and tighten the screws.

Coaxial cable

Step 7

Turn the receiver over and make sure the tabs on the

jack covers sit ﬂush with the bottom of the receiver

chassis.

Step 8

Press the hole caps into the holes on the rear panel.

Step 9

The coaxial cables should route toward the front of the

receiver as shown so the cable ﬁts loosely under the

jack covers. Finger tighten the SMA connectors on the

circuit board.

SMA connectors

Step 10

Replace the chassis cover. Insert the tabs on the front

of the cover ﬁrst, then gently press outward on the rear

panel to allow the cover to slip into place and tighten

the four screws securing the cover.