User's Manual

Digital Hybrid Wireless
®
Modular Receiver System
Rio Rancho, NM, USA
15
Top Menu SYSTEM INFO
Firmware and hardware versions and the serial num-
ber of the unit is listed in the SYSTEM INFO screen.
Resetting to Factory
Defaults
Navigate to SYSTEM INFO in the Top Menu and press
the encoder to enter the screen.
Highlight SYSTEM DEFAULT and press the encoder.
Highlight OK in the next pop-up screen and press the
encoder to restore the factory default settings.
The default settings are as follows:
Level
+00 dBu
Phase
NORMAL
TxBatt
AA ALK
SmartNR
NORMAL
Compat
Dig. Hybrid
Tuning
NORMAL MODE
DivMode
Switched
LockSet
NOT LOCKED
RxCh
8, 0
IR Transmitter Setup
The IR (infrared) port simplifies transmitter setup by
sending the settings saved in the receiver to an IR en-
abled transmitter. The IR port is located on the receiver
front panel next to the power switch.
The transfer is initiated by the receiver. Navigate to
the SETTINGS item in the TX MENU and press the
encoder to open the setup screen. Select the desired
transmitter channel.
After the transmitter channel is selected, choose either
SEND FREQ to send only the frequency or SEND ALL
to send all settings that appear on the LCD.
Select either SEND FREQ or SEND ALL
Hold the transmitter with its IR port facing the receiver
front panel within two feet or so. Press the encoder to
start the transfer. The receiver LCD will display a mes-
sage during the transfer.
Confirmation that the transfer has been completed will
be displayed on the transmitter LCD.