Instruction Manual
SPECIFICATIONS AND FEATURES
Operating frequencies: 470 to 608 MHz, 614 to 806 MHz
Frequency selection: 256 frequencies in 100kHz steps
RF Power output: 100 mW (nominal)
Pilot tone: 32.764 kHz (± 2Hz); 5kHz deviation
Frequency stability: ± 0.002%
Deviation: ± 75 kHz (max)
Spurious radiation: 90 dB below carrier
Equivalent input noise: -126 dBV
Input level: Nominal 2 mV to 300 mV, before limiting.
Greater than 50 Volts maximum, with limiting.
Input impedance: Taps provided for 500, 1k, 10k Ohm
Input compressor: Soft compressor, >30 dB range
Gain control range: 43 dB; semi-log rotary control
Modulation indicators: Dual LEDs indicate modulation level 12 dB below limiting and at
the onset of limiting.
Controls: 3 position "OFF-MUTE-ON" slide switch for noiseless turn
on/turn off operation. Front panel knob adjusts audio gain.
Recessed control on side panel adjusts low frequency rolloff.
Rotary switches on side panel adjust transmitter frequency.
Audio Input Jack: Switchcraft 5 pin locking (TA5F)
Antenna: Detachable, flexible wire supplied. 50 Ohm port allows
connection to test equipment.
Battery: Precision compartment auto-adjusts to accept any known
alkaline 9 Volt battery. (We’ve tried 125 different ones!)
Battery Life: 4.5 Hours with alkaline 9 Volt
Weight: 6.3 ozs. including battery
Dimensions: 3.1 x 2.4 x .75 inches
Emission Designator: 180KF3E
12