User Manual

UHF Digital Hybrid Wireless™ Receiver

Rio Rancho, NM

From the Main window, you can navigate to the Fre-

quency, Battery Level and Setup windows in a circular

sequence by pressing the MENU button.

Frequency Window

TVxx - Indicates the television broad-

cast channel (xx) this frequency falls

within.

Transmitter switch settings (AE in the illustration)

-These are the correct switch settings for the frequency

switches on your transmitter - see your transmitter

instructions.

Frequency - Press the SEL Up and Down buttons to

change the frequency of the receiver.

Note: Be certain to change the transmitter

frequency switches to match the settings shown

in the upper left hand corner of the Frequency

window.

Menu Selections from Main Window

When the TUNING mode is set to NORMAL, the SEL

Up and Down buttons tune in single channel incre-

ments. In the group tuning modes, the SEL Up and

Down buttons move among the selected intermod-free

frequencies.

Tuning shortcuts: In NORMAL tuning mode, MENU+UP

and MENU+DOWN tune in 16 channel increments for

faster tuning. In the group tuning modes, MENU+UP

jumps to the ﬁrst frequency in the group and

MENU+DOWN jumps to the last one in the group.

Battery Level Window

This window shows the transmit-

ter (TX) and receiver (RX) battery

voltage. These levels will ﬂash when

there will be about one hour operating time remain-

ing. The RX voltage changes to EX when operating on

external power and displays the external power source

voltage. (Disclaimer: We cannot guarantee 0.1 Volt ac-

curacy.)

Note: NA M7 & EU M7 are only

available with ﬁrmware 6.0 on the

audio board.