Manual

UCR401
LECTROSONICS, INC.
26
Operating Frequencies (MHz):
Block 470: 470.100 - 495.600
Block 19: 486.400 - 511.900
Block 20: 512.000 - 537.500
Block 21: 537.600 - 563.100
Block 22: 563.200 - 588.700
Block 23: 588.800 - 607.900 and
614.100 - 614.300
Block 24: 614.400 - 639.900
Block 25: 640.000 - 665.500
Block 26: 665.600 - 691.100
Block 27: 691.200 - 716.700
Block 28: 716.800 - 742.300
Block 29: 742.400 - 767.900
Block 944: 944.100 - 951.900
Frequency Adjustment Range: 25.5 MHz in 100kHz steps
Channel Seperation: 100 kHz
Receiver Type: Triple conversion,
superheterodyne, 244 MHz,
10.7 MHz and 300 kHz
Frequency Stability: ±0.001 %
Front end bandwidth: 30 MHz @ -3 dB
Sensitivity
20 dB Sinad: 1 uV (-107 dBm), A weighted
60 dB Quieting: 1.5 uV (-104 dBm), A weighted
Squelch quieting: Greater than 100 dB
AM rejection: Greater than 60 dB, 2 uV to 1 Volt
(Undetectable after processing)
Modulation acceptance: 85 kHz
Image and spurious rejection: 85 dB
Third order intercept: +0 dBm
Diversity method: SmartDiversity
TM
phased antenna combining
FM Detector: Digital Pulse Counting Detector operating
at 300 kHz
Antenna inputs: Two, fixed whip
Audio outputs
Rear Panel XLR: Adjustable from -50dBu to +5dBu
in 1 dB steps. Calibrated into a
typical 10 k Ohm balanced load.
Can drive 600 Ohm load.
Front Panel Controls and Indicators:
LCD control panel Main window: Pilot tone; antenna phase, receiver battery
level; transmitter battery status; audio level,
RF level
Frequency window: Frequency, TV channel;
Transmitter switch setting
Audio output level adjustment: -50 dBu to +5 dBu
Battery level tracking: Receiver (AA battery) in 1/10th volt
steps, accuracy +/- 0.2V.
Transmitter (AA battery) x.xxV
format, accuracy +/- 0.1V.
Timer option available when NiMH used.
Scanning mode: Coarse and fine modes for RF spectrum
site scanning
Audio test tone: 1 kHz, -50 dBu to +5 dBu output, 1% THD
Transmitter battery type selection: 9V alkaline, 9V lithium, AA alkaline,
AA lithium, NiMH
Phase invert: Audio output phase normal or inverted
SmartNR (noise reduction): OFF, NORMAL, FULL modes
(available in 400 Series mode only)
Specifications and Features
Audio Performance (overall system): (These specs apply to 400 Series mode only.)
Frequency Response: 32 Hz to 20 kHz (+/- 1dB)
THD: 0.2% (typical)
Signal to Noise Ratio (dB):
(overall system, 400 Series mode)
SmartNR No Limiting w/Limiting
OFF 103.5 108.0
NORMAL 107.0 111.5
FULL 108.5 113.0
Note: The dual envelope “soft”
limiter provides exceptionally good
handling of transients using variable
attack and release time constants. Once activated, the limiter compresses 30+ dB of transmitter
input range into 4.5 dB of receiver output range, thus reducing the measured figure for SNR
without limiting by 4.5 dB
Total Harmonic Distortion: 0.2% typical (400 Series mode)
Input Dynamic Range: 125 dB (with full Tx limiting)
Rear Panel Controls and features: XLR audio output jack;
External DC input;
Battery compartment access
Power Options:
Ext DC: Minimum 6 Volts to maximum 18 Volts DC;
150 mA at 6 VDC; 75 mA at 18 VDC
Int Batt: Two AA 1.5 Volt alkaline, lithium or
NiMH (270 mA @ 3V)
Battery Life:
AA alkaline 4 hours continuous
AA NiMH 8 hours (2500 mAH)
AA lithium Up to 21 hours (continuous and
intermittent usage are the same)
Weight: 13 oz. with batteries
Dimensions: 2.83” wide x 1.25” high x 4.64” deep
(2.83 mm x 32 mm x 118 mm)
Specifications subject to change without notice