Instruction Manual

UHF Compact Receiver

TROUBLESHOOTING

Before going through the following chart, be sure that you have a good battery in the receiver (or a properly con-

nected AC adapter). The POWER LED should glow brightly.

SYMPTOM POSSIBLE CAUSE

NO POWER LED 1) Receiver switch in “OFF” position

2) Dead or weak battery

3) External 12 Volt power disconnected

4) Receiver switch in wrong position for the power source used

NO RF LED 1) Transmitter not turned on

2) Transmitter battery dead

3) No microphone on transmitter (the microphone

serves as the antenna

4) Receiver antenna not connected

RF LED ON BUT NO SOUND 1) Transmitter switch in “MUTE” position

AND NO MODULATION LEDS 2) Transmitter microphone not connected

3) Microphone switch in “OFF” position

4) Possible malfunction in the audio section of the

transmitter. See transmitter manual

5) Check transmitter modulation LEDs for possible

transmitter problem

MODULATION LED’s ON 1) Receiver LEVEL control turned down

BUT NO SOUND 2) Audio cable disconnected

3) Recorder or sound system off, or not properly adjusted

REPLACEMENT PARTS AND ACCESSORIES

Part No. Description

CH-12 110 Volt AC adapter for UCR190 receiver

CC-MINI System pouch, zippered, for compact wireless systems

A-500S UHF Flexible whip receiver antenna, straight

A-500RA UHF Flexible whip receiver antenna, right angle

PS-12 Power cable, Hi-rose 7-4 pin (Betacam) to DC power supply (UCR190)

PS-212 Same as PS-12 except with dual plugs to power 2 UCR190 receivers

Rio Rancho, NM – USA