User's Manual

SRc5P and SRc Dual Receivers
LECTROSONICS, INC.
12
SR9VBP 9 Volt Battery Adapter
This optional adapter is mounted onto the battery sled
for use as the primary power source or as a battery
backup for an external power supply. The housing and
door are constructed of machined aluminum.
Slide the latch plate in the center of the door outward
and swing the door open for access to two 9 volt battery
compartments. Polarity barriers in each battery com-
partment protect against inserting the battery back-
wards. The circuitry is also protected electrically.
A pressure plate on the battery door compresses the
battery contacts to maintain a solid connection with
the batteries.
The mechanical and electrical connections are the
same as the rechargeable video camera batteries.
CAUTION: DO NOT
CONNECT TO A BATTERY
CHARGER. USE ONLY TWO
SAME TYPE BATTERIES.
SRSLEEVE mounting adapter
This sleeve is supplied with Velcro swatches for mount-
ing an SR Series receiver on a flat surface of camera,
cart, rack, etc. The sleeve is sized and lined for a snug
fit in a vertical or horizontal position.
SRHARDWARE mounting adapter kit
Cold shoe
mounting foot
P/N 26752
Washer
P/N 28912
Jam nut
P/N 28898
Bracket
P/N 26739
Thumb nut
P/N P1241-1
Hex Key
P/N 35931
Retaining pins
P/N 28865
Long pan
head screw
P/N 28876
Short pan
head screw
P/N 28898
For a vertical mounting, attach the right angle bracket to
the bottom of the sleeve.
Long pan
head screw
P/N 28873
Attach retaining
pin to keep bracket
from rotating
1/4-20
insert nut
1/4-20 clinch
pressnut
Retaining pin
opening
The bracket provides
two different mount-
ing nuts. The stan-
dard pressnut is used
to attach the sleeve.
The tensioning (clinch
type) pressnut is used
to attach the cold
shoe mounting foot.