Instruction Manual

SRb5P and SRb Dual Receivers
LECTROSONICS, INC.
2
Quick Start Summary
The following checklist includes the minimum required
settings to start using the receiver.
• Installeitherstand-aloneorcameraslotadapterkit,
theantennasandpositionthereceiverasitwillbe
used(seepages9-12).
• Connectpowertothereceiver(seepages10,11).
• SettheDIVMODEforsingleordualchannelopera-
tion(seepage15,16).
• SettheCOMPAT(compatibility)modeforthetrans-
mitterstobeused(seepages15,16).
• Findclearoperatingfrequenciesforoneorboth
receivers(seepages19-21).
• Settransmittersonthematchingfrequencies(see
transmittermanual).
• Verifytransmittersaresettothesamecompatibility
modeasthereceiver(seetransmittermanual).
• Adjusttransmitterinputgaintomatchvoicelevel
andmicposition(seetransmittermanual).
• Adjustreceiveroutputlevelasneededforthecam-
eraormixerinputleveldesired(seepages15,16).
IMPORTANT:
FREQ.
WARNING
Performance will be degraded if
Receiver 2 is set 4.2 to 4.8 MHz higher
than Receiver 1. The LCD will also flash
this message periodically.