User's Manual

Digital Hybrid Wireless Belt-Pack Transmitters
Rio Rancho, NM
7
Transmitter Operating
Instructions
• Install battery(s)
• Turn power on in the Standby mode (see previous
section)
• Connect microphone and place it in the position
where it will be used.
• Have the user talk or sing at the same level that will
be used in the production, and adjust the input gain
so that the -20 LED blinks red on louder peaks.
Gain
Freq
Rolloff
Compat
-40
-20
0
Gain
25
Use the UP and DOWN
arrow buttons to adjust
the gain until the -20
LED blinks red on
louder peaks
Signal Level -20 LED -10 LED
Less than -20 dB
Off Off
-20 dB to -10 dB
Green Off
-10 dB to +0 dB
Green Green
+0 dB to +10 dB
Red Green
Greater than +10 dB
Red Red
• Set the frequency and compatibility mode to match
the receiver.
• Turn the RF output on with the Rf On? item in the
power menu, or by turning the power off and then
back on while holding the power button in and wait-
ing for the counter to reach 3.
Recorder Operating
Instructions
• Install battery(s)
• Insert microSDHC memory card
• Turn power on
• Format memory card
• Connect microphone and place it in the position
where it will be used.
• Have user talk or sing at the same level that will be
used in the production, and adjust the input gain so
that the -20 LED blinks red on louder peaks
Gain
Freq.
Rolloff
Compat
-40
-20
0
Gain
25
Use the UP and DOWN
arrow buttons to adjust
the gain until the -20
LED blinks red on
louder peaks
Signal Level -20 LED -10 LED
Less than -20 dB
Off Off
-20 dB to -10 dB
Green Off
-10 dB to +0 dB
Green Green
+0 dB to +10 dB
Red Green
Greater than +10 dB
Red Red
• Press MENU/SEL and choose Record from the
menu
A
503.800
-40
-20
0
E
b 19
REC
Files
Format
Record
Gain
RECORD-
ING
• To stop recording, press MENU/SEL and choose
Stop; the word SAVED appears on the screen
SAVED
Files
Format
Stop
Gain
A
503.800
-40
-20
0
E
b 19
To play back the recordings, remove the memory card
and copy the files onto a computer with video or audio
editing software installed.