Instruction Manual

Super-Minature Belt Pack Transmitter
Rio Rancho, NM
9
SMV/SMQV/X
• 100 Series mode: CP 100
• 200 Series mode: CP 200
• Mode 3
(contact the factory for details): CP 3
• 400 Series mode: CP 400
• IFB Series mode: CP IFB
• Mode 6
(contact the factory for details): CP 6
4) Press either AUDIO or FREQ button to select the
power setting screen and use the Up and Down
down arrows to select the desired level of power.
5) Simultaneously press the AUDIO and FREQ but-
tons to exit this mode and turn off the power.
Audio Screen
The Audio screen is used to
adjust input gain from 0 to
+44 dB, and the low frequen-
cy roll-off from 35 to 150 Hz.
Repeatedly pressing the
AUDIO button toggles back
and forth between the two
displays. Press and hold the AUDIO button and use the
Up and Down arrows to make adjustments.
Frequency Screen
The Frequency Screen
displays the operating
frequency in MHz or as a
two-digit hexadecimal
number that corresponds
to the equivalent
Lectrosonics Frequency
Switch Setting. Repeat-
edly pressing the FREQ button toggles between the two
displays. Press and hold the FREQ button and use the
Up and Down arrows to select the frequency.
Lock/Unlock Screen
Simultaneously pressing
and holding both the Up
and Down arrow buttons
during normal operation
starts the Lock timer. The
timer starts at three and
counts down to zero.
When the timer reaches zero, the transmitter’s controls
are locked.
With the controls locked, the AUDIO and FREQ buttons
can still be used to display current settings. Any attempt
to change a setting by pressing either the Up or Down
arrow button will result in an on-screen Loc reminder
that the controls are locked. Remove the batteries to
unlock the control panel.
Important: Once the transmitter is locked, it
cannot be unlocked or powered off using the
buttons. The only ways to unlock a locked
transmitter are to remove the battery or unlock it
via the RM remote control.
Remote Control Operation
Remote Control Screens
The transmitters can be
configured to respond to
signals from the LectroRM
app or to ignore them.
This setting is accessed
by holding Down arrow
button while powering the
transmitter on. Use the
arrow keys to toggle be- tween “rc on” (remote con-
trol on) and “rc oFF” (remote control off). The default
setting is “rc on.”
If a remote control signal is detected but the transmitter
is set to “rc oFF”, the message “rc oFF” will be dis-
played briefly on the transmitter’s LCD, to confirm that a
valid signal was received, but that the transmitter is not
configured to respond to it.
Remote functions available are:
• Tx Input Gain
• Sleep/Unsleep
• Lock/Unlock
• Frequency
• Tuning in 25 kHz steps
• Changing the low frequency roll-off setting
• Turning on/off the PWR and Audio LEDs
• Gain up/down functions
In sleep mode, the transmitter uses only 20% of the
normal amount of battery drain. Sleep mode can only be
invoked with the remote control, and can only be revoked
with the remote control or by removing the battery. When
in the sleep mode, the PWR LED blinks green every few
seconds to indicate that the transmitter is asleep and not
turned off.