User Manual

SMV Series
LECTROSONICS, INC.
8
Operating Instructions
Power Up and Boot Sequence
1) Ensurethatgoodbatteriesareinstalledintheunit.
2) Simultaneously press and hold the AUDIO and
FREQbuttonsuntilthePowerOnBootSequenceis
initiated.
The count will progress from 1
through 3 and the unit will then
power up with the RF output
turned on. During this turn on sequence, the
modulationandpowerLEDsallglowred,then
green, and then revert to normal operation.
The LCD displays a bootup sequence which con-
sists of four screens:
Company Name: Lectro
Frequency Block (bXX) and
Firmware Version (rX.X): b21r1.1 (typ)
Power Level Pr 250
Compatibility Mode: CP 400 (typ)
Audio: Aud 12 (typ)
Power Down
Initial Power Off
Timer Screen
1) Simultaneously press and hold the AUDIO and
FREQbuttonswhileobservingthattheword“Off”
appears in the LCD along with a counter.
2) Whenthecounterreaches“0”,theunitturnsoff.
Note:IftheAUDIOandFREQbuttonsare
released before the LCD goes blank at the end of
the countdown, the unit will not turn off. Instead, it
willstayenergizedandthedisplaywillreturntothe
previous screen.
Standby Mode
Standby Screen
Withthepowerturnedoff,
pressing the AUDIO and
FREQbuttonsbrieyplaces
the unit in Standby Mode. In
this mode the RF output is
turned off so all setup adjustments can be made
without interfering with other systems operating in the
same location. The screen displays “rf OFF” to remind
the user that the unit is not transmitting.
Whiletheunitisinthestandbymode,accessthesetup
screensusingtheAUDIOandFREQbuttonsandmake
adjustments using the Up and Down arrows.
LCD Backlight Settings
The LCD backlight can be set to turn off after either 5
minutes or 30 seconds or stay on continuously. Hold
the UP arrow in while powering up the unit to enter
the setup screen. Press the AUDIO button repeatedly
to step through the setup items to reach the backlight
settingsscreen.UsetheUPorDOWNarrowbuttonto
select the desired setting.
Selecting the Compatibility Mode
and Output Power
Power setting
400 Series or Digital
Hybrid Wireless™
compatibility mode
The transmitter will work with
200 Series, 100 Series and
IFB analog receivers, plus
some other analog wireless
receivers in addition to the
native digital hybrid mode.
Note: The unit
automatically enters the
Standby Mode when
selecting compatibility.
1) Set the receiver’s audio controls to minimum.
2) From a power off condition, hold down the Up
arrow, then simultaneously press the AUDIO and
FREQbuttons.
3) Press either AUDIO or
FREQbuttontoselectthe
compatibility screen and
use the Up and Down ar-
rows to select the desired
mode.
The following Compatibility
Modes are available:
 •100Seriesmode: CP100
 •200Seriesmode: CP200
 •Mode3(contact the factory for details): CP 3
 •400Seriesmode: CP400
 •IFBSeriesmode: CPIFB
 •Mode6(contact the factory for details): CP 6
4) PresseitherAUDIOorFREQbuttontoselectthe
power setting screen and use the Up and Down
down arrows to select the desired level of power.
5) SimultaneouslypresstheAUDIOandFREQbut-
tons to exit this mode and turn off the power.`
Power Restore Screens