INSTRUCTION MANUAL Quadpack Power/Audio Adapter Power & Audio Adapter for SRa Series Compact Receivers Fill in for your records: Serial Number: Purchase Date: Rio Rancho, NM, USA www.lectrosonics.
QUADPACK Table of Contents General Technical Description...........................................................................................................................................................3 Side Panels..........................................................................................................................................................................................3 Receiver Installation..............................................................................
Receiver Power & Audio Adapter General Technical Description Designed for portable applications in the field, the Quadpack simplifies the mounting and interconnection of two SRa receivers for 4 audio channels. The Quadpack’s lightweight and rugged design make it perfect for bag systems, leaving you plenty of room for your mixer, recorder and transmitters for audio feed to cameras.
QUADPACK Receiver Installation Installing Receivers To Quadpack First install the SRUNI rear panel adapter. Receiver Removal Removing Receivers From Quadpack Remove receivers from the Quadpack by first loosening the 4 mounting screws, inserting the Delrin tool into the notch and prying upward to release the receiver from the DB25 connector. The mating 25-pin connector inside each slot on the Quadpack provides power and audio connections.
Receiver Power & Audio Adapter Replacement Parts & Accessories 21586 6 ft. long power cable; locking LZR style plug to stripped and tinned leads. 21746 Power cable with locking, right angle connector to stripped and tinned; 12 inch length. 21762 Neutrik right angle XLR male connector with 5 selectable cable outlet positions; cast metal housing BATTSLED PSLZRDUAL CH20 Rio Rancho, NM General purpose adapter for L or M style rechargeable batteries. For use as primary or backup power supply.
QUADPACK Specifications Dimensions: Weight: Assembly only: With 2-SRa5P receivers: With 2-SRa5P receivers: Power Interface Connector: Audio Outputs: Power: Power Requirements: H 4.95 in. x W 9.40 in. x D 1.40 in. 1 lbs., 5 ozs. (0.6614 kg) 2 lbs., 3 ozs. (1.031 kg) 2 lbs., 4 ozs. (1.077 kg) dB-25 (Unislot) 4 Balanced XLR-Male 4 Balanced TA3-Male Hirose 4-pin Coaxial (LZR) 7 to 18 VDC 400 mA max Specifications subject to change without notice 6 LECTROSONICS, INC.
Receiver Power & Audio Adapter Service and Repair If your system malfunctions, you should attempt to correct or isolate the trouble before concluding that the equipment needs repair. Make sure you have followed the setup procedure and operating instructions. Check the interconnecting cables and then go through the Troubleshooting section in this manual.
LIMITED ONE YEAR WARRANTY The equipment is warranted for one year from date of purchase against defects in materials or workmanship provided it was purchased from an authorized dealer. This warranty does not cover equipment which has been abused or damaged by careless handling or shipping. This warranty does not apply to used or demonstrator equipment. Should any defect develop, Lectrosonics, Inc. will, at our option, repair or replace any defective parts without charge for either parts or labor.
