User's Manual

Digital IEM System
Rio Rancho, NM
7
2-channel Operation
NOTE: the transmitter must be also in 2 ch. mode
for the receiver to operate in this manner.
2-ch. mode allows for three different knob setups:
• Master(1,2)
This is the factory default and is equivalent to
standard IEM systems where only a stereo signal
is used. The tall, thin knob is the stereo master
volume.
• Master(1)+2
Feeds audio channel 1 to the master volume (tall,
thin knob) and audio channel 2 to the middle knob
for independent control.
• 1+2
Gives you individual control over both audio
channels. Audio channel 1 is fed to the tall thin
knob, and audio channel two is fed to the middle
individual knob. In this setup, there is no master
volume knob. You can develop a stereo mix by
panning each channel in the stereo field (see pan-
ning, below).
MASTER
VOLUME
AUDIO CH.
1
2
NO
FUNCTION
NO
FUNCTION
2 CHANNEL - Master (1,2) mode
(factory default)
MASTER
VOLUME
2 CHANNEL - Master (1) + 2 mode
AUDIO
CH. 1
AUDIO
CH. 2
MASTER
VOLUME
NO
FUNCTION
AUDIO
CH. 1
AUDIO
CH. 2
2 CHANNEL - 1 + 2 mode
NO
FUNCTION