User's Manual

QUADRA
LECTROSONICS, INC.
6
LCD
Thebootsequencewillbrieydisplaythecompany
logo, model number and firmware revision.
Following the boot-up sequence, the receiver will re-
verttotheMainWindow,showingthefollowing:
• Operatingfrequencyattheupperleft(Frq1,Frq2,
etc. for 4-ch or Split 4-ch operation, Frq1a, Frq1b,
Frq2a for 2-ch operation)
• RFlevelmeter(alongthetopedgeoftheLCD)
• Audiolevelmetersinthemiddleofthedisplay
(either two or four, depending on operating mode)
• Knobsetupalongthebottom(Mstr(1,2)+3,4;
Mstr (1) + 2, 3, 4, etc.)
Receiver Menus
Toaccessthesetupmenus,pressthe“MENU/SEL”
button at the upper left of the membrane panel. To
back up one level or return to the “home screen”, press
the“BACK”button.TheUPandDOWNarrowbuttons
along the right side of the control panel allow you to
navigate between menu options and to adjust specific
parameters within the setup screens.
Battery status is indicated by a GREEN LED. The
LED turns REDtoindicatethatyourbatteriesare2/3
depleted. FLASHING RED indicates that you should
replace your batteries as soon as possible.
Selecting 2-channel or
4-channel Operation
The Chan. Setup screen allows you to select whether
the receiver operates in 2 ch., 4-ch. or split 4-ch.
modes, and then how the knobs on the top of the
receiver are configured as a mixer.
Each Chan. Setup screen allows setting of 2-channel
and 4-channel modes, plus a second line for selection
of the knob configurations.
2/4 channel
selection
knob
configuration
Press MENU/SEL to toggle the highlight between the
Chans and KnoblinesandusetheUPandDOWN
arrow keys to make selections.