User's Manual

Digital IEM System

Rio Rancho, NM

Limiter

This feature can be used in order to provide audio lim-

iting at the receiver in order to prevent excessive levels

at the headphones or earbuds. To set the amount of

limiting, highlight “Limiter” in the menu list using the ar-

rowkeys.Press“MENU/SEL”tochoosethisfunction.

Use the arrow keys to select the limiter threshold in

3dB increments. Test it with a known signal to deter-

mine the maximum sound level you are comfortable

with. The pre-gain setting can then be used to boost

the audio level before the limiter. Use this feature if you

need to make up for a weaker signal at the transmitter.

UsetheMENU/SELbuttontochoose“Pre-Gain”,then

use the arrow buttons to adjust in 3 dB increments.

Backlight

The backlight control page allows you to select the

length of time before the backlight turns off on the re-

ceiver. The factory default setting is 5 minutes, but you

can also select 30 seconds or “Always on.”

Treble Shelf

In this screen, you can choose a treble boost with a

corner either at 5kHz or 7kHz, and a boost of up to

9dB in 3dB increments. This feature can be used to

overcome a stereo mix without enough high frequency

information, or earbuds that “roll off” too early in the

high frequency area.

This high-frequency boost should be used sparingly

due to the fact that it can accelerate hearing loss with

high volumes in the earphones or headphones. Note:

the factory default setting is 5 kHz corner with 0dB

boost.

Lock Setup

This feature is used to lock the control panel so that

no further changes can be made. Once “Locked” is se-

lected, note that a small lock icon is at the upper right

ofeachsetupmenuscreen.Withthereceiverlocked,

you can view each menu screen but you are unable to

make changes and the power can not be turned off.

To return to the unlocked status, go back to the “Lock

Setup” screen via the main menu, and select “Un-

locked”. Also, note that the “Locked” status is main-

tained even if the batteries are changed.

Factory Default

This is used if you intend to reset the receiver to all the

factory default settings.