User's Manual

Compact Portable Receiver
Rio Rancho, NM
19
Step 3:
Refer to Step 1 to return to Firmware web page. Down-
load Firmware Update and save to a local file on your
PC for easy locating when updating.
Step 4:
Open Lectrosonics USB Firmware Updater.
Step 5:
Using a microUSB cable, connect the transmitter to
your PC.
Step 6:
Put the transmitter in
UPDATE mode by simul-
taneously holding down
the UP and DOWN arrow
buttons on the transmitter
control panel while
powering it up.
Step 7:
In Lectrosonics USB Firmware Updater, choose the
detected device, browse to local Firmware File and
click Start.
NOTE: It may take up to a minute or so for the
Updater to recognize the transmitter.
WARNING: Do not disrupt the microUSB cable
during updating.
The Updater alerts with progress and completion.
Step 8:
Once the Updater has
completed, turn off the
transmitter, then turn it
back on to verify that the
firmware version on the
transmitter LCD matches
the firmware version
shown on the web site.
The firmware is located
on the first LCD display
during boot up sequence,
top right-hand corner.
Step 9:
Close Updater and disconnect microUSB cable.