User's Manual

581 Laser Road NE • Rio Rancho, NM 87124 USA • www.lectrosonics.com
[phone] • [phone] • fax [phone] • [e-mail]
Industry Canada Notices:
Operation of this device is subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept interference, including interference that may cause undesired operation of the device.
This device has been designed to operate with the antennas listed below, and having a maximum gain of 6 dB. Antennas
not included in this list or having a gain greater than 6 dB are strictly prohibited for use with this device. The required
antenna impedance is 50 ohms.
 •LectrosonicsmodelA500RAwhipantenna
 •LectrosonicsmodelSNA500dipoleantenna
Power listed is conducted. The antenna(s) used for this transmitter are to be fixed-mounted on indoor permanent
structures providing a separation distance of at least 20 cm from all persons during normal operation. The maximum
radiatedoutputpowerateachantennamustsatisfytheMPECategoricalExclusionRequirementsof§2.1091.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for successful communication.
FCC Notices:
Emission designator: 180KF3E
TheIFBT4transmitterisFCCtypeacceptedunderPart74:470-608MHz,614-806MHzand944.1–951.9MHz.
This device complies with FCC radiation exposure limits as set forth for an uncontrolled environment. This device should
be installed and operated so that its antenna(s) are not co-located or operating in conjunction with any other antenna
ortransmitter.Aseparationdistanceofatleast20cm(8inches)mustbemaintainedtocomplywiththeFCCRadio
Frequency Maximum Permissible Exposure (MPE) requirements.