User's Manual

IFBR1a, IFBR1a/E01, IFBR1a/E02
LECTROSONICS, INC.
12
Operating frequencies (MHz):
US E02
Block 470 470.100 - 495.600 779.125 - 787.875
Block 19 486.400 - 511.900 797.125 - 805.875
Block 20 512.000 - 537.500 806.125 - 809.750
Block 21 537.600 - 563.100
Block 22 563.200 - 588.700
Block 23 588.800 - 607.900 and 614.100 - 614.300
Block 24 614.400 - 639.900
Block 25 640.000 - 665.500
Block 26 665.600 - 691.100
Block 27 691.200 - 716.700*
Block 28 716.800 - 742.300*
Block 29 742.400 - 767.900*
Block 944 944.100 - 951.900
E01
Block 470 470.100 - 495.600
Block 19 486.400 - 511.900
Block 20 512.000 - 537.500
Block 21 537.600 - 563.100
Block 22 563.200 - 588.700
Block 23 588.800 - 607.900 and 614.100 - 614.300
Block 24 614.400 - 639.900
Block 25 640.000 - 665.500
Block 26 665.600 - 691.100
Block 27 691.200 - 716.700*
Block 28 716.800 - 742.300*
Block 29 742.400 - 767.900*
Block 30 768.000 - 793.500
Block 31 793.600 - 819.100
Block 32 819.200 - 844.700
Block 33 844.800 - 861.900
Block 606 606.000 - 631.500
*Available for export only
NOTE: It’s the user’s responsibility to select the approved
frequencies for the region where the transmitter is operating.
Specifications and Features
Number of frequencies: 256 per block (79 in block 944, 172 in block 33)
Channel spacing: 100 kHz
Frequency control: Crystal Controlled Phase Locked Loop
Sensitivity: 1 uv (20 dB SINAD)
Signal/Noise ratio: 95 dB A-weighted
Squelch quieting: 90 dB
AM rejection: 50 dB, 10 uv to 100 mv
Modulation acceptance: ±20 kHz
Spurious rejection: Greater than 70 dB
Third order intercept: 0 dBm
Frequency response: 100 Hz to 10 kHz, (±1db)
Pilot tone: 29.997 kHz, 4.5 kHz deviation
(fixed crystal controlled)
Audio output, headphone: 1 Volt RMS into 50 ohms minimum
Antenna: Headphone cable
Min. headphone impedance: 25.6 Ohms
Programmable memory: Switches set default frequency; up to 10 additional
frequencies can be stored in memory
Front panel controls: Single knob controls Audio Output Level,
Power on, programming and Scan Frequency Selection
Indicators: 1 tricolor LED Indicator for power on, blinks to
indicate channel number, blinks fast during scan,
and turns yellow or red for low battery
Battery Requirement: 9V alkaline battery lasts about 8 hours
9V lithium battery lasts about 20 hours
Power consumption: 60 mA
Allen wrench for knob: 0.035” (Lectro part number: 35854)
Weight: 7.3 oz with battery
Size: 3.6 x 2.4 x 0.8 inches (91.44 x 60.96 x 20.32 mm)
Specifications subject to change without notice.