User's Manual

DSQD Manual

LECTROSONICS, INC.

4. Insert two (2) cap screws (Part #28885) through the

rack handle (Part #27082) holes and install the rack

handle onto the ﬂange bracket through the holes in

the unit’s front panel. Firmly tighten the cap screws

using the hex key (Allen wrench) as shown.

5. If antennas will NOT be mounted on the front panel

of the receivers, install the hole cap (Part #35959)

by aligning the ﬂat on the cap with the ﬂat on the

opening.

Installing two DSQD

Receivers into a Single

Rack Space

The DSQD receiver occupies a half rack space, and

comes with hardware to mount two receivers into a

single rack space.

1. Remove the Trim Cap (Part #P1330) from both

sides of the front panel on both receivers.

2. Remove the breakaway tabs on both sides of the

chassis side panels. Use a ﬂat blade screwdriver

to pry the tabs outward and snap them off of the

chassis.

3. Insert the ﬂange bracket (Part #27076) into the

open slot in the side of the chassis cover panel.

NOTE: The retaining nuts on the panel and tie

brackets are “tensioning lock nut” types designed

to prevent the screws from coming loose due to

vibration. You will usually feel resistance as you

tighten the screws - this is normal.