Manual

Ratio Diversity Receiver

SPECIFICATIONS AND FEATURES

Operating frequencies: 150 to 216MHz, crystal controlled

Sensitivity: -110dBm for 20dB Sinad (0.7uV)

Signal/noise ratio: 96dB flat; 99dB A-weighted

Squelch quieting: Greater than 109dB

AM rejection: Below the noise at all input levels

Modulation acceptance: Greater than ±15kHz

IF Selectivity: 150kHz interference bandwidth; -30dB @ ±200kHz

Third order intercept: +5dBm

Diversity technique: Dual receiver “opti-blend” audio combining

Audio outputs: XLR: 200 Ohm bal.; 100mV max.

Antenna inputs: Dual BNC female; 50 Ohm impedance

Controls: Front panel attenuator controls balanced outputs; Power switch

Indicators: Red LED for power “ON”; Dual modulation LEDs show

transmitter audio level; Dual “opti-blend” LEDs display mixture

ratio; Code ON LED

Power requirements: 12V DC (rear panel jack); 110V AC (using supplied CH-12

AC adapter)

Power consumption: 170mA max

Weight: 10.1 ozs

Dimensions: 3¼” wide, 1¼” high, 5¼” deep

Specifications subject to change without notice

Rio Rancho, NM – USA