User's Manual

Digital Plug-On Transmitter
Rio Rancho, NM
7
Operating Instructions
MENU/SEL Button
BACK Button
Modulation
LEDs
PWR LEDUP Arrow
DOWN
Arrow
KEY LED
POWER Button
Turning Power ON
Powering On in Operating Mode
Press and hold the POWER Button briefly until the
progress bar on the LCD finishes.
When you release the button, the unit will be operation-
al with the RF output turned on and the Main Window
displayed.
Hold
for
Rf On
DPr
00 : 02 : 37
-20
+0
470.100
-40
RF indicator not blinking
Hold power
button until
the progress
bar finishes
Powering On in Standby Mode
DPr
00 : 02 : 37
-20
+0
470.100
-40
RF indicator blinks
A brief press of the POWER
button and releasing it before the
progress bar finishes, will turn the
unit on with the RF output turned
off. In this Standby Mode the
menus can be browsed to make
settings and adjustments without
the risk of interfering with other
wireless systems nearby.
Powering Off
Powering
O...
To turn the unit off, hold the POW-
ER Button in briefly and wait for the
progress bar to finish. If the
POWER button is released before
the progress bar finishes, the unit
will remain turned on and the LCD
will return to the same screen or
menu that was displayed previ
ously.
Transmitter Operating
Instructions
• Install battery(s)
• Turn power on in the Standby mode (see previous
section)
• Connect microphone and place it in the position
where it will be used.
• Have the user talk or sing at the same level that
will be used in the production, and adjust the
input gain so that the -20 LED blinks red on
louder peaks.
Input...
Gain
Rolloff
Phase
-40
-20
+0
Gain
22
Use the UP and DOWN
arrow buttons to adjust
the gain until the -20
LED blinks red on
louder peaks
Signal Level -20 LED -10 LED
Less than -20 dB
Off Off
-20 dB to -10 dB
Green Off
-10 dB to +0 dB
Green Green
+0 dB to +10 dB
Red Green
Greater than +10 dB
Red Red
• Set the frequency to match the receiver.
• Set encryption key type and sync with receiver.
• Turn the power off and then back on while holding
the POWER button in and waiting until the prog-
ress bar finishes.