User's Manual

Digital Plug-On Transmitter
Rio Rancho, NM
19
21750 Barrel Adapter
This polarity reversing adapter may be needed to
correct for asymmetrical current draw in some P48
powered condenser microphones, including older
Neumann 100 Series, Rode NTG3 and others. If your
microphone does not power on correctly when used
with these transmitters, insert the adapter between the
transmitter and microphone.
5510 Flash Memory Card
Flash Memory Card. MicroSDHC
toSD Adapter included.
AMM(xx)
Whip antenna; straight. Specify frequency block (see
chart below). Included with unit at purchase.
About Whip Antenna Frequencies:
Frequencies for whip antennas are specified by the
block number. For example, AMM-25 is the straight
whip model cut to the block 25 frequency.
L-Series transmitters and receivers tune across a
range covering three blocks. The correct antenna for
each of these tuning ranges is the block in the middle
of the tuning range.
Band Blocks Covered Ant. Freq.
A1 470, 19, 20 Block 19
B1 21, 22, 23 Block 22
C1 24, 25, 26 Block 25
MCA-M30 Barrel Adapter
Mic adapter for Earthworks M30
microphone with HM, DPR and
UH400a/TM transmitters.
This adapter may be needed if
you are experiencing noise or
distortion with measurement
microphones, particularly the
Earthworks M30. The adapter has a common mode
choke for suppressing RF noise. If your microphone sig-
nal exhibits the problems listed above when connected
to a UH400, HM or DPR transmitter, insert the adapter
between the microphone and the transmitter. Insert the
adapter between the transmitter and microphone to al-
leviate these issues.
MCA5X
This is an optional adapter for connecting a lavaliere
microphone to the DPR or HM transmitters. TA5M to
XLR3-M connectors. Passes transmitter phantom power
to bias the electret lavaliere microphone. Includes zener
protection to limit bias voltage to protect the microphone
if transmitter phantom power is set too high.
MCA-TPOWER
This cable adapter is to be used
with the UH200D, UH400, HM
and DPR plug-on transmitters
with T-powered microphones. It
will protect a T-power mic against
the 48V phantom power setting
in the transmitter while allowing
normal operation. The transmitter should be set to the
15V position for best operation and minimum battery
drain.
PHTRAN3-A
Replacement leather pouch with clear plastic screen
cover, rotating belt clip and snap closure. Included with
unit at purchase.
Replacement Parts and Accessories