Owner manual

DNT Digital Processor
LECTROSONICS, INC.
8
DNT Control Panel
Software
DNT Series processors are set up and monitored us-
ing the DNT Control Panel program. The software will
run on a Windows or Mac operating system.
Use the disk included with every processor to install
the software, or download the installer from the web
site at:
http://www.lectrosonics.com/dntsupport/
DNT Software Installation
NOTE: Uninstall previous version before
installing the software.
Insert the disk into the drive and wait for the Welcome
Screen to appear. Click on Install DNT Software/USB
Drivers to install the software.
The End User License Agreement screen appears.
Click on I Agree, then on Next to continue.
The next screen presents options on which compo-
nents to install. It is recommended that you check all
three so the Help System and USB Driver will be
installed automatically.
Click on Install to continue.
A status bar will appear during the installation to
advise you of the progress. Wait for the installation to
complete, then click Next to finalize the process.
Another screen will appear during the installation,
prompting for permission to install the USB drivers.
Click on Next to continue.
When the installation is complete the final screen will
appear. Click on Finish to close the installer.