User's Manual

Digital Camera Hop Receiver
Rio Rancho, NM
5
Battery Status LED
When the battery status LED on the keypad glows
green the batteries are good. The color changes to red
at a midpoint during the runtime. When the LED begins
to blink red, only a few minutes remain.
The exact point at which the LED turns red will vary
with battery brand and condition, temperature and
power consumption. The LED is intended to simply
catch your attention, not to be an exact indicator of
remaining time. The proper battery type setting in the
menu will increase accuracy.
A weak battery will sometimes cause the LED to glow
green immediately after the transmitter is turned on,
but it will soon discharge to the point where the LED
will turn red or the unit will turn off completely.
RF Link LED
When a valid RF signal from a transmitter is received,
this LED will light up blue.
IR (infrared) Port
Settings, including frequency, name, compatibility
mode, etc. can be transferred between receiver and
transmitter.
Outputs
Headphone Monitor
A recessed, high duty cycle 3.5 mm stereo jack is pro-
vided for standard headphones and earphones.
Audio Jack (TA5M mini XLR):
• AES3
• Analog Line Out
The 5-pin input jack accommodates two discrete
channels at microphone or line levels. The input
connections are configured as follows:
ANALOG DIGITAL
Pin 1 CH 1 Shield/Gnd AES GND
Pin 2 CH 1 + AES CH 1
Pin 3 CH 1 - AES CH 2
Pin 4 CH 2 + --------------
Pin 5 CH 2 - --------------
1
2
3
4
5
TA5FLX connector
viewed from outside
USB Port
Firmware updates via Wireless Designer software are
made easy with the USB port on the side panel.
Battery Compartment
Two AA batteries are installed as marked on the rear
panel of the receiver. The battery door is hinged and
remains attached to the housing.
Keypad and LCD Interface
MENU/SEL Button
Pressing this button enters the menu and selects
menu items to enter the setup screens.
BACK Button
Pressing this button returns to the previous menu or
screen.
POWER Button
Pressing this button turns the unit on or off.
Arrow Buttons
Used to navigate the menus. When on Main Screen,
UP Button will turn LEDs on and DOWN Button will
turn LEDs off.