User's Manual

Digital Belt-Pack Transmitter
Rio Rancho, NM
5
Features and Functions
Belt Clips
The wire belt clip may be removed by pulling the ends
out of the holes in the sides of the case. Be sure to
have a firm grip to avoid scratching the surface of the
housing.
An optional spring-loaded, hinged belt clip (model num-
ber BCSLEBN) is also available. This clip is attached by
removing the plastic hole cap on the back of the hous-
ing and mounting the clip with the supplied screw.
IR (infrared) Port
The IR port is available on the top of the transmitter for
quick setup using a receiver with this function available.
IR Sync will transfer the settings for frequency from the
receiver to the transmitter.
PWR/FUNC
AUDIO
-20
-10
IR PORT
u
470.100
-40
-20
+0
DBu
USB Port
Belt clip
mounting hole
Modulation
Indicators*
Programmable
Function Switch
Audio
Input
Jack
Antenna
Port
Belt clip
mounting hole
Battery
status LED
Full access to all settings is provided through the key-
pad and LCD. The transmitter can also be configured
as a “one button” device by locking the ability to make
changes with the keypad, and configuring the top panel
switch as either power on/off or a mute function.
Battery
compartment
door
Key verification
LED
Menu navigation
buttons
Power button
Return to
previous screen
*When the transmitter is set to MUTE, the -10 Modula-
tion Indicators LED will glow solid red. Otherwise, the
-10 Modulation Indicators LED will glow solid green
when transmitter is on.
IR Port
Remove hole cap to
attach spring loaded
belt clip