User's Manual

DBu-LEMO, DBu-LEMO/E01
LECTROSONICS, INC.
6
Operating Instructions
Powering On in Operating Mode
Press and hold the Power Button for several seconds
until a moving bar on the LCD progresses.
Hold
for
Rf On
DBu
V1.13
/1.05
470.100
-40
-20
+0
DBu
When you release the button, the unit will be operation-
al with the RF output turned on and the Main Window
displayed.
Powering On in Standby Mode
A brief press of the Power Button , and releasing it
before the moving bar progresses, will turn the unit on
with the RF output turned off. In this Standby Mode the
menus can be browsed to make settings and adjust-
ments without the risk of interfering with other wireless
systems nearby.
Hold
for
Rf On
Release Power
Button before
the moving bar
progresses to
enter standby
mode
470.100
-40
-20
+0
DBu
RF indicator blinks
After settings and adjustments are made, press the
power button again to turn the unit off.
Powering Off
Powering
O . . .
From any screen, power can be
turned off by selecting Pwr Off in the
power menu, holding the Power
Button in and waiting for the
moving bar to progress, or with the
programmable switch (if it is config-
ured for this function).
If the power button is released, or the top panel switch
is turned back on again before the moving bar pro-
gresses, the unit will remain turned on and the LCD will
return to the same screen or menu that was displayed
previously.
NOTE: If the programmable switch is in the OFF
position, power can still be turned on with the
power button. If the programmable switch is then
turned on, a brief message will appear on the LCD.
Power Menu Options
Entering the Power Menu
With the unit turned on, press the power button once
briefly from any menu or screen and a menu will appear
with several options. Use the and arrow buttons
to highlight menu items. Then press MENU/SEL to
execute the item or enter a setup screen. The following
options are available:
• Resume - returns to the previous mode and screen
• Pwr Off - turns the unit off irrevocably
• Rf On? - enters a screen to enable the operating or
standby modes
• AutoOn? - allows the unit to automatically turn
back on after a power failure or when fresh batter-
ies are installed (works in the operating mode only)
• Backlit - adjusts the duration of the LCD back light
to 5 seconds or 30 seconds, or to remain on
• About - displays model number and firmware
version