User Manual

DBa
LECTROSONICS, INC.
12
Locking/Unlocking Changes to Settings
Changes to the settings can be locked to prevent inad-
vertent changes being made.
Locked?
Ye s
No
-40
-20
0
Gain
25
A small padlock symbol will appear on adjustment
screens when changes have been locked.
Phase
BatType
BatTime
Locked?
When changes are locked, several controls and actions
can still be used:
• Settings can still be unlocked
• Menus can still be browsed
• Programmable switch still works
• Power can still be turned off by using the power
menu or removing the batteries.
Adjusting LCD Backlight
For viewing the LCD in dimly lit conditions, the backlight
can be turned on continuously or set to turn off auto-
matically after either 30 seconds or 5 minutes.
Backlit
About
Default
Wipekey
Backlit
On
30 Sec
5 min
About
Displays the model of the transmitter and the firmware
version.
Backlit
About
Default
Wipekey
About
DBa
V0.03
Restoring Default Settings
This is used to restore the factory settings.
Backlit
About
Default
Wipekey
Default
settings
No
Ye s
Wipekey
The encryption key can be erased with this setup
screen.
Backlit
About
Default
Wipekey
WipeKey?
No
Ye s
Encryption key and settings transfer
A cable between the receiver and the micro USB port
on the side of the transmitter is used to transfer the
encryption key from the receiver to the transmitter. This
connection can also be used to send the transmitter
settings stored in the receiver to the transmitter.
The interface cable, P/N DRKEYCABLE, is used to
make this connection.
NOTE: Reference the DSW System Instruction
Manual for instructions on Encryption Key settings
and software.