User's Manual

DSW Digital Wireless System
LECTROSONICS, INC.
12
(TX MENU cont’d)
LF ROLLOFF adjusts the point at which the
low frequency audio in the transmitter begins
to roll off. This “knee” can be set at 35, 50, 70,
100, 120 or 150 Hz.
TX PHASE reverses the polarity of the audio
signal in the transmitter to match other
microphones in the system that vary with
different microphone types and connector wiring.
NOTE: The audio polarity on each output channel
on the receiver can also be reversed in the RX
MENU.
PROG SWITCH configures the function of the
switch located on the outside of the housing
on the transmitter. The switch can be config-
ured to be an audio mute switch, a power on/off switch
or to be disabled.
AUTO ON sets the transmitter to either turn
back on and resume operation after a battery
change, or to require being manually turned
back on again.
NOTE: The AUTO ON feature works only when the
RF output carrier is turned on.
TX PANEL LOCK prevents inadvertent
changes to be made on the transmitter
keypad. The menus can still be browsed to
view the settings, but changes cannot be
made.
BATT TIMER is used to determine the
remaining battery life based upon a test of the
batteries in use. This is especially useful when
rechargeable batteries are being used. Reset the time
with the setup screen. Charge the batteries fully, then
run them down in the transmitter with the timer running
to determine the available runtime.
TX BACKLIGHT adjusts the length of time
that the backlight remains lit on the transmit-
ter LCD. Options are 30 seconds, 5 minutes
or to remain on.
RXMENU
FREQ ADJUST allows manual selection of
the operating frequency.
AUDIO LEVEL provides a setup screen with
adjustments of the analog audio output level
for each channel, plus a tone output on each
channel for use in adjusting the input level of a con-
nected device or sound system.
MONITOR AUDIO adjusts the level of each
channel that appears at the headphone jack
on the front panel. Options include individual
output level, program audio, or tone and either isolated
channel monitoring or a mix of all channels.
SMART NR (smart noise reduction) allows
the selection of the noise reduction mode on
each channel. Options include NORMAL,
FULL and OFF.
PHASE inverts the polarity of the analog
audio outputs on the receiver.
AUDIO OUTPUT selects analog or AES
digital modes for the receiver outputs. Adja-
cent modules are paired in the selection.
MODULE POWER turns each receiver
module on or off.