User's Manual

4-channel Digital Wireless System
Rio Rancho, NM, USA
9
D4T Transmitter
Audio Level Setup
Press FUNC and then select the menu item “Audio
Lev. “ and press FUNC again. The setup screen for
audio level will vary slightly depending upon which
AES3 mode has been selected. If the 2-channel mode
has been selected, channels 3 and 4 will appear blank
on the setup screen.
Use UP/DOWN
arrows to select
menu item and
press FUNC to
enter setup
When configured for four AES/EBU
outputs, the channel levels will be preset
to the AES standard.
1 2 3 4
When configured for two digital and two
analog inputs, press the button under the
analog channel to be adjusted and then
use the UP and DOWN buttons to set the
desired level.
1 2 3 4
In this example, the transmitter is
configured for four analog channels. Select
each channel with the button below it and
use the UP and DOWN arrow buttons to
set the desired level.
NOTE: The transmitter is designed for line
level signals. There is no gain stage in the input
section. Attenuation up to 20 dB can be applied to
the input signal to reduce very high level signals
to the optimal range for the transmitter.
D4R Receiver
Audio Level Setup
Press FUNC and then select the menu item “Audio
Lev. “ and press FUNC again. The setup screen for
audio level will vary slightly depending upon which
AES3 mode has been selected. If the 2-channel mode
has been selected, channels 3 and 4 will appear blank
on the setup screen.
Use UP/DOWN
arrows to select
menu item and
press FUNC to
enter setup
When configured for four AES/EBU
outputs, the channel levels will be preset
to the AES standard.
1 2 3 4
When configured for two digital and two
analog inputs, press the button under the
analog channel to be adjusted and then
use the UP and DOWN buttons to set the
desired level.
1 2 3 4
When configured for four analog outputs,
press the button under the channel to be
adjusted and then use the UP and DOWN
buttons to set the desired level.
NOTE: The value shown in the setup screen
on the receiver is the level of an analog signal
in dBu at the output when the RF signal is fully
modulated. AES/EBU outputs are preset to the
industrystandardvalue,sonoadjustmentis
needed.