User's Manual
4-channel Digital Wireless System
Rio Rancho, NM, USA
13
Industry Canada Notices:
Operationofthisdeviceissubjecttothefollowingtwo
conditions:(1)thisdevicemaynotcauseinterference,
and(2)thisdevicemustacceptinterference,including
interference that may cause undesired operation of the
device.
This device has been designed to operate with the
antennalistedbelow,andhavingamaximumgainof6
dB. Antennas not included in this list or having a gain
greaterthan6dBarestrictlyprohibitedforusewith
this device. The required antenna impedance is 50
ohms.
Linx Technologies model: ANT-916-CW-HWR-RPS
To reduce potential radio interference to other users,
the antenna type and its gain should be so chosen that
theequivalentisotropicallyradiatedpower(e.i.r.p.)is
not more than that permitted for successful communi-
cation
FCC Notice
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuanttoPart15oftheFCCRules.Theselimits
are designed to provide reasonable protection against
harmful interference in a residential installation. The
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorientorrelocatethereceivingantenna
• Increasetheseparationbetweentheequipment
and receiver
• Connecttheequipmentintoanoutletonacircuit
different from that which the receiver is connected
• Consultthedealeroranexperiencedradio/TV
technician for help
Changes or modifications to this equipment not ex-
pressly approved by Lectrosonics, Inc. could void the
user’s authority to operate it.