Owner manual

SPECIFICATIONS
Operating Frequencies:
RF Sensitivity:
IF Selectivity:
Squelch Quieting:
AM Rejection:
Modulation Acceptance:
Third Order Intercept:
Distortion:
Signal/Noise Ratio:
Audio Outputs:
Antenna Input:
Controls:
Indicators:
Power Requirements:
Power Consumption:
Weight:
Dimensions:
169 to 186 MHz, crystal controlled
–110 dBm for 20 dB Sinad (0.7 uV)
• 150 kHz interference bandwidth
• –30 dB @ ±200 kHz
–109 dB
below the noise at all input levels
±15 kHz
+5 dBM
0.5% @ 1 kHz, 12 kHz deviation (system)
–90 dB (system)
XLR: 200 Ohms bal; 100 mV max.
Front Panel Monitor: “Off” to –20 dBm
BNC; 50 Ohms impedance
• Front panel attennuator controls XLR output
• Recessed trim-pot controls headphone
• 3 position power/function switch
• Red LED for power ON
• 2 LEDs for mod level
• RF LED for transmitter ON
• 12 Volts DC external (either polarity)
• 110 Volts AC via CH-12 AC adapter
• Single 9 Volt alkaline battery
70 mA @ 12 kHz deviation, 61 mA @ idle
11 ounces including battery
1.1 x 2.75 x 5.2 inches
Specifications subject to change without notice
10