Level 1 / Level 2 EV Charger for J1772 USER MANUAL
In the Box Mobile connector Charging handle 5-15 plug 14-50 plug Warnings • It is recommended that electrical outlets for your mobile connector be installed by a licensed and qualified electrician. To avoid serious injury or death, installation must comply with the provisions of the National Electric Code (NEC) and all local codes. In cases of any conflict between the local codes and the NEC, local codes shall take precedence. • This product must be grounded.
Safety Information When using your charger, always follow basic precautions including the following: • Read warnings on the back of the mobile connector and all instructions in this manual before operating. • Never use the mobile connector with a power strip. • Never use the mobile connector with an AC adapter/transformer. • Shock hazard – make sure the plug is fully inserted into the wall outlet so that there are no exposed blade surfaces.
Charging Your Vehicle Ensure that the car is parked and the engine is turned OFF. 1. Insert the plug into a powered wall outlet. 2. Once powered on, the mobile connector display will show 3 LED lights and a blinking ring, indicating that it is ready to charge your EV. Slow blinking LED ring Continuous LED lights Note: Find all charging statuses on the back of the mobile connector.
3. Plug the handle into your vehicle’s charging port. 4. Charging begins automatically. The 3 LEDs will start blinking and the LED ring will light up. Always double check your EV dashboard to make sure it is being charged. Continuous LED ring Blinking LED lights Note: Find all charging statuses on the back of the mobile connector.
5. When the vehicle is fully charged, the 3 LEDs will blink and the outer ring will stay solid. Double check your EV dashboard to make sure it is fully charged. Fully Charged Continuous LED ring + 0 km 6/6 A 210 V Slow blinking LED lights 6. Remove the handle from your vehicle.
Troubleshooting Please refer to this troubleshooting guide for possible solutions to common problems while charging. Problem Mobile connector display does not illuminate. Vehicle will not charge. Possible Cause No power to the mobile connector. 1. Check the circuit breaker and other circuit loads. 2. Try another wall outlet. 3. Ensure that the plug is fully inserted into the wall outlet. Mobile connector internal failure. Contact Lectron customer support at contact@ev-lectron.com for assistance.
Charging Status Table All of the charging statuses can be found on the back of the mobile connector.
Specif i cations Maximum voltage: Frequency: Maximum Current: Cable Length: Plug: EV connector: Dimensions: Weight: Operating Temp: 240 VAC 50 Hz 16 A / 32 A 21 ft (6.4 m) NEMA 5-15 / 14-50 Compatible with J1772 9.45 x 3.5 x 2.4 in 4.5 kg -22 °F to +122 °F (-30 °C to +50 °C) Get More Support Scan the QR code to contact us or send us an email at contact@ev-lectron.com. For more information, visit: www.ev-lectron.
