User manual

Operator's Manual
919586 RevA
153
 Touch the CDR control and select from Linear, Filtered, and Short-Term choices.
 The next two controls allow you to either enter a specific Bit Rate, or have MIPI M-PHY find your signal's
bitrate.
 Finally a convenient SDA Menu... button is available for quick access to the main SDA dialog.
THE VIEWS DIALOG (INCLUDING THE SHOW EYE CONTROL)
Touch the Views tab and the Views dialog is shown.
Note: Some of the controls on this dialog are enabled/disabled based on Mode, Probing, and Input Selection
control choices.
This dialog includes controls for Data Diff, Eye, Mask Mode, CDR, Common-mode, PSD, CM Load, Fall, and Rise.
As controls are used, MIPI M-PHY processes the information and responds in real time.
The Show Eye Control
Marking this checkbox shows the eye diagram trace on the display area and includes a corresponding trace
descriptor label.