User manual

Serial Data Debug Solutions
116
919586 RevA
Status Sub-Type and Right-Hand Dialog
When the Status sub-type is selected, the Status right-hand dialog is made available. Provide RT Address field
values for Condition, Value and To (for range conditions). Select Status Word Setup values (0, 1, or X) for Error,
Instr, SRQ, Bcast Rcvd, Busy, Sub Syst, Dyn Bus, and Term Flg.
5. ERROR SUB-TYPE AND RIGHT-HAND DIALOG
When the Error sub-type is selected, a correspondingly named Error right-hand dialog is shown.
Note: Right-hand dialogs are located in the area shown on label 5 of the screen-shot in the MIL-STD-1553
Trigger Setup Detail (on page 107) topic.
Error Sub-Type and Right-Hand Dialog
Mark/unmark checkboxes as desired for Word and Transfer Level Errors. The Select all Errors, and Deselect all
Errors buttons are available for convenience.
5. TIMING SUB-TYPES AND RIGHT-HAND DIALOGS
When the Timing Type is selected, the Response Time and Inter Message Gap Sub-Types are available on the
main dialog.
Response Time and Inter Message Gap Sub-Types show correspondingly named right-hand dialogs as follows:
Note: Right-hand dialogs are located in the area shown on label 5 of the screen-shot in the MIL-STD-1553
Trigger Setup Detail (on page 107) topic.