User manual
Serial Data Debug Solutions 
118 
919586 RevA 
Handset, Cellular, and Mobile Computing Protocols 
Handset, Cellular, and Mobile Computing Protocols Overview 
DigRF 3G 
The DigRF 3G is a Mobile Industry Processing Interface (MIPI) standard for wireless mobile RFIC to BBIC mobile 
device interfaces. 
The standard is maintained by MIPI Alliance. Additional information, including the specification, can be found at 
www.mipi.org/. 
Number of Lines 
Data rate 
Synchronous or Asynchronous 
2 
312 Mb/s 
Asynchronous 
DigRF 4G 
The DigRF 4G is a Mobile Industry Processing Interface (MIPI) standard for wireless mobile RFIC to BBIC mobile 
device interfaces. 
The standard is maintained by MIPI Alliance. Additional information, including the specification, can be found at 
www.mipi.org/. 
Number of Lines 
Data rate 
Synchronous or Asynchronous 
2 
312 Mb/s 
Asynchronous 
D-PHY (CSI-2/DSI) 
The MIPI D-PHY (CSI-2/DSI) is another Mobile Industry Processing Interface (MIPI) standard. 
The standard is also maintained by MIPI Alliance. Additional information, including the specification, can be 
found at www.mipi.org/. 
Number of Lines 
Data rate 
Synchronous or Asynchronous 
2 
Up to 1 Gb/s 
Asynchronous 
M-PHY 
The MIPI M-PHY is another Mobile Industry Processing Interface (MIPI) standard. 
The standard is also maintained by MIPI Alliance. Additional information, including the specification, can be 
found at www.mipi.org/. 
Number of Lines 
Data rate 
Synchronous or Asynchronous 
2 
Up to 1 Gb/s 
Asynchronous 
Using the DigRF 3G Option 
Using the DigRF 3G Option Overview 
The DigRF 3G option displays the digital conversion of I and Q RF signals, and then displays the entire frame 
structure, including the Sync field, Header, Payload Size coding, and Payload. 
Note: Ask your local LeCroy representative for more information about any Serial Data Debug Solution 
Protocols or Toolkits using the Contact LeCroy for Support (on page 199) topic. 
DigRF 3G Decode Setup Detail 
For general information about using controls shown on the main Serial Decode dialog, refer to Accessing The D 
and TD Supported Protocol Toolsets (on page 13). 










