User manual

CANbus Trigger, Decode, and Measure
58
CANbus-TD-TDM-OM-E RevB
7
CANH
Yellow
8
VB+ or VB
BATT
Red
Notes:
Connect Pin 3 as necessary, depending on whether it is low sped or single-wire CAN
Use for low-speed (1054) or single-wire (GM-LAN, 5790c) CAN
(ISO 11898-3, ISO 11519, SAE J2411)
Cable Part Number 902381-00
DSUB (9-pin) Pin #
Definition
Wire Color
2
CANL
White
7
CANH
Yellow
Notes:
A 120 ohm terminating resistor is connected across pins 2 and 7, in accordance with IS0
11898.
Use for high-speed (251, 1050, 1041) CAN
(ISO 11898-2)
VERIFYING PROPER TRIGGER MODULE CONNECTION TO THE CAN BUS
The CANbus TD/TDM Trigger Module has several LEDs on the front of the module. These LEDs
will light to indicate CAN message direction and error frame activity. There is one set of LEDs for
each input (or Trigger Coupler). The LEDs will light as follows:
LED
Indication
RX
Flashes when messages are being
received