User manual

CANbus Trigger, Decode, and Measure

CANbus-TD-TDM-OM-E RevB

Note: Be sure to avoid touching the bottom or top of the Trigger Couplers or the Trigger Module

main boards. If you are unsure, use normal static grounding techniques.

5. The Trigger Coupler is held down with a screw

and locknut. Use a Philips #1 screwdriver to

remove them. If necessary, carefully remove a

Trigger Coupler from the main board, taking

care not to touch the bottom of the Trigger

Coupler. Store the Trigger Coupler in one of the

static sensitive boxes (provided).

6. Install a new Trigger Coupler, making sure that

the two-row connector and one-row connector

are properly aligned and that the pins are fitting

correctly. Refasten screw and locknut.