Manualshelf

User manual

ManualsBrandsLECROY ManualsTest & Measurement AccessoriesWSXS CANBUS TD trigger and decoder extension Compatible with WaveSurfer® Oscilloscopes.
21222324252627282930
CANbus Trigger, Decode, and Measure
24
CANbus-TD-TDM-OM-E RevB
CAN-to-Analog Parameter Setup
To access the setup dialog, touch Setup for that particular parameter on the CAN
Measure/Graph Setup dialog. The Px Parameter dialog will be displayed. On the right side of this
dialog box, there is an additional setup dialog:
The CAN Message tab defines the CAN Message Setup. The Analog Signal tab defines the Analog
Signal Setup.
Note: The CAN Message tab always defines the CAN Message Setup and the Analog Signal tab
always defines the Analog Signal setup even if you are measuring time from an Analog Signal
to a CAN Message. The CAN Message setup is nearly identical to the setup of the CAN message
in the CAN Trigger dialog, so details will not be repeated here.
The Analog Signal setup dialog is shown below: