User manual

SET UP
12
924853-00
Micro SD Card
The Micro SD Card acts as the oscilloscope’s removable hard drive. Use
it to store and easily share setup files, waveform trace files, LabNotebook
notebooks, and related data.
When using the oscilloscope Disk Utilities, the Micro SD Card appears as
Storage Card, while a connected USB drive appears as USB Disk.
Probes
WaveSurfer 3000 oscilloscopes are compatible with the included passive
probes and all Teledyne LeCroy ProBus active probes that are rated for
the oscilloscope’s bandwidth. Probe specifications and documentation
are available at teledynelecroy.com/wavesurfer3000.
LAN
WaveSurfer 3000 accepts DHCP network addressing. Connect a cable from
either Ethernet port on the back panel to a network access device. Go to
Utilities > Utilities Setup > Remote and select TCPIP to obtain a network
connection and IP address.
To configure a Static IP address, touch Net Connections on the Remote
dialog and enter the address.
Go to Utilities > Preference Setup > Email to configure email settings.
External Monitor
WaveSurfer 3000 supports external monitors with 1028 x 600 resolution.
Connect the monitor cable to the VGA video output on the back of the
instrument. The connection is “plug-and-play” and does not require any
further configuration on the oscilloscope. If necessary, configure the
monitor to receive output.
Printer
WaveSurfer 3000 supports PictBridge-compliant printers. Connect the
printer to any host USB port. The connection is “plug-and-play.”