User manual
Operator's Manual
Memory
The oscilloscope is equipped with twointernal memory slots (Mx) to which you can copy any channel, math,
zoom or other special waveform that is active on the grid. This is a convenient way to store an acquisition
for later viewing and analysis.
Memories are created at the same scale as the source trace, but they can be adjusted independent of the
original by using the Zoom controls that appear next to the Mx dialogs.
Save Waveform to Memory
1. With the source waveform displayed on the grid, press the front panel Mem button or choose Math >
Memory Setup to open the Memories dialog.
2. Touch the Mx tab corresponding to the memory slot you wish to use.
NOTE: Try to choose an empty slot, as anything currently stored in that location will be overwritten. All
memories will state if they are empty or an acquisition is stored there.
3. In Copy from Waveform, choose the source trace to copy to memory.
4. Touch Copy Now.
5. Optionally, check Trace On to immediately display the memory. The memory will open in the same grid
as the source trace. Use the Zoom controls to adjust the scale of the memory while it is turned on.
Restore Memory
1. Access the Memories dialog by pressing the front panel Mem button or choosing Math > MemorySetup.
2. Check On next to the memory you wish to display. A description of the memory showing the source
channel and creation time appears next to each Mx on the dialog.
81