User manual

Operator's Manual
Measure
Measurement parameters are tools that give you access to a wide range of waveform properties. Use them
to analyze many attributes of your waveform such as rise-time, rms voltage, and peak-to-peak voltage.
You can create a custom set of up to six parameters drawn from all the standard measurements, as well as
specialized measurements installed with optional software packages.
Measurement readouts appear in a table below the grid. Readouts can be individually turned on/off. To
quickly access the Measure Setup dialog if it is closed, touch any cell of the readout table.
Measurement readout table open below grid showing statistics and histicons.
Measurements can be viewed in graphical format to facilitate your analysis. See Trend.
Setting Up Measurements
To configure custom measurements to add to the table of parameter readouts:
1. From the menu bar, choose Measure > Measure Setup.
2. Check Show Table to display the readout on screen.
3. Touch the Measure button next to an unused Px location (or one that you want to change), then choose
the measurement from the pop-up window.
4. For each input required by the measurement, touch Source and select the waveform to be measured.
65