User manual

Operator's Manual
DIGITAL INTERVAL
1. Choose the Source input line.
2. Choose the Slope (edge) from which to measure.
3. Choose the Logic Family that marks the High-Low logic threshold. To enter a custom threshold, choose
Logic Family User Defined and enter the voltage Level.
NOTE: The Logic Family will default to any Logic Setup associated with that line in a previous digital
group setup.
4. Use Interval Condition is settings to create an expression describing the triggering interval. This may be:
l Any width Less Than an Upper Value.
l Any width Greater Than a Lower Value.
l Any width In Range or Out Range of values. You may describe the range using either:
l Limits, an absolute Upper Value and Lower Value.
l Delta, any Nominal width plus or minus a Delta width.
53