User manual

5
WaveSurfer 3000 Getting Started Guide
INTRODUCTION
Operational Environment
Temperature: 0° to 50° C
Humidity: Maximum relative humidity 90% for temperatures up to
31° C decreasing linearly to 50% relative humidity at 50° C
Altitudes: up to 3,048 m (at < 30° C)
Power and Ground Connections
The instrument operates from a single-phase, 100 to 240 Vrms (± 10%)
AC power source at 50/60 Hz (± 5%), or a 100 to 120 Vrms (± 10%) AC
power source at 400 Hz (± 5%). The instrument automatically adapts to
the line voltage. Manual voltage selection is not required.
The AC inlet ground is connected directly to the frame of the instrument.
For adequate protection again electric shock, connect to a mating outlet
with a safety ground contact.
WARNING. Interrupting the protective conductor inside or outside
the oscilloscope, or disconnecting the safety ground terminal,
creates a hazardous situation. Intentional interruption is prohibited.
Maximum power consumption with all accessories installed (e.g., active
probes, USB peripherals, digital leadsets) is 150 W (150 VA) for four-
channel models and 100 W (100 VA) for two-channel models. Power
consumption in standby mode is 4 W.
Cleaning
Clean only the exterior of the oscilloscope using a damp, soft cloth. Do
not use harsh chemicals or abrasive elements. Under no circumstances
submerge the instrument or allow moisture to penetrate it. Avoid electric
shock by unplugging the power cord from the AC outlet
before cleaning.
CAUTION. Do not attempt to clean internal parts.
Fuse Replacement
Disconnect the power cord before inspecting or replacing the fuse. Open
the fuse holder (located at the rear of the instrument below the AC power
inlet) using a small, flat-bladed screwdriver. Replace the old fuse with a
new 5 x 20 mm T-rated 3.15 A/250 V fuse. Close the fuse holder before
powering on.
WARNING. For continued fire protection at all line voltages, replace
the fuse with one of the specified type and rating only. Always
disconnect the power cord before replacing the fuse.
Support
Online Documentation
Teledyne LeCroy publishes a free Technical Library on its website.
Manuals, tutorials, application notes, white papers, and videos are
available to help you get the most out of your Teledyne LeCroy products.
The WaveSurfer 3000 Oscillosocopes Operator’s Manual can be
downloaded from teledynelecroy.com/wavesurfer3000. This .PDF
document contains more extensive procedures for operating your
oscilloscope than are found here.
The Datasheet published on the product page contains the detailed
product specifications.
Technical Support
Registered users can contact their local Teledyne LeCroy service center
at the number listed in this guide to make Technical Support requests by
phone or email. You can also submit Technical Support requests via the
website at teledynelecroy.com/support/techhelp.