User manual

BASICS
33
WaveSurfer 3000 Getting Started Guide
Memories (Reference Waveforms)
Memories are traces stored for reference. They can be recalled to the
display for comparison with other traces. A memory can be zoomed or
measured for better analysis of historical data. You can store up-to-two
internal memories (M1-M2). After that, new memories will overwrite
previously stored data.
Internal memories only persist until the oscilloscope is rebooted. To store
memories indefinitely, save them to an external file by choosing File >
Save Waveform. The file can then be recalled into one of the two internal
memories for viewing by choosing File > Recall Waveform. Only memory
files saved with the extension .trc can be recalled.
Press the front panel Mem(ory) button to open the Memory dialog.
To turn on stored memory, check On next to M1-M2.
To store new memory, touch M1-M2 button or tab.
A
B
C
D
E
A
B
C
D
E
Select source trace in Copy From Waveform.
Add notes describing contents of memory.
Touch to copy to internal memory.