Manualshelf

User manual

ManualsBrandsLECROY ManualsLaboratory Test EquipmentDigital 350 MHz 4-channel 2 null 10 null 8 Bit Digital storage (DSO)
11121314151617181920
SET UP
11
WaveSurfer 3000 Getting Started Guide
Carrying
The oscilloscope’s case contains a built-in carrying handle. Always
unplug the instrument from the power source before lifting and carrying it.
Powering On/Off
Connect the line cord rated for your country to the AC power inlet on the
back of the instrument, then plug it into a grounded AC power outlet. (see
Power and Ground Connections in “General Safety Information”).
The Power button controls the operational state of the oscilloscope.
Press the button to switch on the instrument; the LED on the button lights to
show the oscilloscope is on. Press it again to switch “off” (Standby power).
CAUTION. Do not power on or calibrate the oscilloscope with a
signal attached.
Always use the Power button or the File > Shutdown menu option to
execute a proper shut down process and preserve settings.
The Power button does not disconnect the oscilloscope from the AC
power supply; some “housekeeping” circuitry continues to draw power.
The only way to fully power down the instrument is unplug the AC line
cord from the outlet.
CAUTION. Do not place the instrument so that it is difficult to reach
the power cord in case you need to disconnect from power.
We recommend unplugging the instrument if it will remain unused for a
long period of time.
Connecting
After start up, configure the connection on the oscilloscope using the menu
options listed below. See the WaveSurfer 3000 Oscilloscopes Operator’s
Manual for more detailed instructions.
USB Peripherals
Connect the device to a USB port on the front or back of the instrument. Go
to Utilities > Utilities Setup > Hardcopy to configure printer settings.
External Controller
Connect a USB-A/B cable from the USBTMC port on the back of the
instrument to the controller. Go to Utilities > Preference Setup > Remote to
configure remote control.
WaveSource Waveform Generator (to other device)
Connect a BNC cable from the WaveSource connector on the back of the
instrument to the other device. Go to Utilities > WaveSource or touch the
front panel WaveSource button to configure the output signal.
Other Auxiliary Device
Connect a BNC cable from Aux Out on the back of the instrument to the
other device. Go to Utilities > Utilities Setup > Aux Output to configure the
connection.