User manual

Operator's Manual
Turning On/Off Traces
Analog Trace
From the display, choose Vertical > Channel <#> Setup to turn on the trace. To turn it off, clear the Trace On
checkbox on the corresponding Channel dialog.
From the front panel, press the Channel button (1-4) to turn on the trace; press again to turn it off.
Digital Trace
From the display, choose Vertical > Digital <#> Setup.
From the front panel, press the Dig button, then check Group on the Digital<#> trace dialog. Clear Group to
turn off the trace.
Other Traces
You can quickly create zoom or math traces without leaving the setup dialogs by touching the Zoom or Math
toolbar button at the bottom of the dialog. Also use the front panel Zoom, Math, or Mem(ory) buttons to
quickly create traces.
Activating Traces
A trace descriptor box appears on the display for each enabled trace. Touch this box at any time to activate
the trace; touch it again to open the setup dialog. A highlighted descriptor box indicates the active trace to
which all actions apply.
Inactive trace descriptor (left), active trace descriptor (right).
Although several traces may be open and appear on the grid, only one at a time is active. When you activate
a trace, the dialog at the bottom of the screen automatically switches to the appropriate setup dialog for that
trace. The tab at the top of the dialog shows to which trace it applies.
Active descriptor label matches active setup dialog tab.
15