User manual

WaveSurfer 3000 Oscilloscopes
EUROPEAN CONTACT:
Teledyne LeCroy Europe GmbH
Waldhofer Str 104
D-69123 Heidelberg
Germany
Tel: [phone]
Australia & New Zealand Declaration of Conformity– EMC
Oscilloscope complies with the EMC provision of the Radio Communications Act per the following standards,
in accordance with requirements imposed by Australian Communication and Media Authority (ACMA):
EN 55011:2010 Radiated and Conducted Emissions, Group 1, Class A, in accordance with EN61326-1:2013
and EN61326-2-1:2013.
AUSTRALIA / NEW ZEALAND CONTACTS:
Vicom Australia Ltd.
1064 Centre Road
Oakleigh, South Victoria 3167
Australia
Australia Vicom New Zealand Ltd.
60 Grafton Road
Auckland
New Zealand
Safety Compliance
EC Declaration of Conformity– Low Voltage
The oscilloscope meets intent of EC Directive 2006/95/EC for Product Safety. Compliance was
demonstrated to the following specifications as listed in the Official Journal of the European Communities:
EN 61010-1:2010 Safety requirements for electrical equipment for measurement, control, and laboratory use
– Part 1: General requirements
EN 61010-2:030:2010 Safety requirements for electrical equipment for measurement, control, and laboratory
use – Part 2-030: Particular requirements for testing and measuring circuits
The design of the instrument has been verified to conform to the following limits put forth by these
standards:
l Mains Supply Connector: CAT II local distribution level, equipment connected to the mains supply (AC
power source).
l Measuring Terminals: CAT I signal level, equipment measuring terminals connected to source circuits
where measures are taken to limit transient voltages to an appropriately low level.
l Unit: Pollution Degree 2, operating environment where normally only dry, non-conductive pollution
occurs. Conductivity caused by temporary condensation should be expected.
l Unit: Protection Class I, grounded equipment in which protection against electric shock is achieved by
Basic Insulation and a connection to the protective ground conductor in the building wiring.
118