User manual

WaveStation

WSta-OM-E RevA

Press adjacent Operation buttons and use the Digital Input Front Panel

Controls (on page 27) to make specific adjustment/selection parameter

choices.

Sweep Operation menu selections and parameters include SwpTime,

StopFreq, FreqSpan, StartFreq, MidFreq, Source, TrigOut, Linear/Log,

and Direction as follows:

 SwpTime - This parameter sets the overall sweep time span in

which the frequency changes from specified start frequency to

stop frequency values.

 StopFreq - Provide a specific frequency value where the sweep

must end.

 FreqSpan - Provide an overall span or range in which the sweep

must remain.

 StartFreq - Provide a specific frequency value where the sweep is

to begin.

 MidFreq - Specify a frequency where the center of the sweep

must remain.

 Source - Select Internal, External, or Manual. If External is

selected, use the Trig/Gate/Fsk/Burst connector on the Back

Panel (on page 14). You can also select Manual and specify exact

start and stop times.

 TrigOut - Select Off or Open. Open sets trigger on the rising edge

of the waveform.